-
-
The main areas to clean include the bed, the vice, behind and in front of the bed, and the pan.
-
Be sure to throw away all trash and put tools away (circled in red are calipers, parallels, and paper towels).
-
-
-
Remove the tool out of the machine
-
Wipe any chips off the parallels and return them to the box
-
Put the box back in the cabinet in the drawer labeled Mill Tools
-
-
-
Use a brush to clean the bed, inside the vice, and the general area
-
NOTE: It is best to clean this machine from top to bottom. Brush off all chips to the pan below or on the ground.
-
-
-
Continue to use the brush to clean the back part of the machine, behind, and in front of the bed.
-
NOTE: Use the spinny thingies to move the bed around to really clean in the crevices!
-
-
-
Use the brush to clean any fallen chips off the table at the side and into the pan
-
-
-
Use the brush the sweep all the chips into the innermost part of the pan on both sides.
-
-
-
Use the vacuum to clean up all the chips inside the pan
-
-
-
Use a broom and dustpan to clean the floor and general area
-
Throw away any trash that may have fallen on the floor as well!
-
-
-
The machine and floor should be clean now!
-
Almost done!
Finish Line