Connex: Wiper Cleaning

Options -> Wizards -> Wiper Cleaning

After the wiper is exposed, slide one finger under the top left corner of the beam and keep one finger on the bottom right corner

Using the right corner as leverage, lift up the left side, popping the wiper out of the socket

Be careful not to bend the 8 metal strips holding the rubber wipers

If the metal strips bend, the wiper will not come in contact with the print heads

Set the wiper on a blue towel and Isopropyl Alcohol and a microfiber cloth

Soak the microfiber cloth with IPA

Start by cleaning the sturdy frame, making sure to wipe down all the corners

Clean in-between the rubber wipers and the frame, dragging the cloth slowly to catch resin

Using a single layer of the microfiber cloth, "floss" between each rubber wiper

To insert wiper back into the printer, insert the wiper from the non-slotted end first

Support the black frame with one finger underneath and push the metal frame into the socket

Once the right side is in, push the left side into the notch and the wiper will be in place

If the black frame is not supported, it will get pushed down, you can reset the black frame by pushing back the door under the south side of the opening