Introduction
The Drying Oven for the Desktop Metal Shop system “crosslinks” the green parts from the printer. This procedure essentially activates and cures the binding agent, and holds the parts together for subsequent post-processing steps.
The oven should be cleaned after every usage of the drying oven, otherwise powder will begin to accumulate and it can become dangerous.
Images by: Terrapin Works
Parts
No parts specified.
-
-
If needed, vacuum any visible areas of metal dust
-
Use the brush attachment, and be careful not to spread the powder too much
-
Vacuum the inside surfaces gently and slowly
-
Be careful to not poke the fragile part of the rear panel
-
-
-
Use an lint-free cloth or towel with deionized water and begin to wipe the interior of the oven
-
Wipe down the seal, constantly changing sides on the cloth or towel
-
Wipe down the interior and underside of the door
-
Do NOT wipe the inside surfaces with DI water as they will always be dusty
-
