Introduction
This guide is about how to prep the Dremel 3D45 for a print job.
Tools
Parts
No parts specified.
-
-
Push down on the two tabs at the ends of the build platform
-
Lift out the glass build plate and out of the machine
-
-
-
Spray water directly on the build surface
-
Wipe the glue residue from the build area until the glass surface is visibly clean
-
-
-
Apply a layer of glue to the surface of the build plate where the part will go
-
-
-
Place the glass build plate back into the Dremel
-
Make sure the black clips secure the build plate
-
Press firmly to lock both clips into place
-
-
-
Watch the printer's first layer to ensure that proper layer adhesion is happening
-
If the first layer is obviously not adhering correctly, begin to level the build plate and try again.
-
Cancel: I did not complete this guide.
11 other people completed this guide.
