Keyence VR-3200 Performing Basic Metrology

After scanning, you'll be able to see the result with the original color or you can switch the preview to Height that shows height differences

You can click analyze to go to the analyzer software, but for this guide click back

You don't have to run the scan to perform part measurment

Select Observe to start the part measurement

If you had to stitch the scan, select analyze data and plane measurement

Some of these measurement features include:

2 points

Parallel

Diameter and Radius

Angle

Measures distance between 2 points

Select 2 points

Click on the object to set two points where you want to measure the distance between them

Click on the screen to set the measurement in place

Measures distance between 2 parallel lines

Select parallel

Click on the place you want to measure from and then click again where you want the straight line to be create

Then click on the place you want to measure to and it will automatically make a parallel line there

Click on the screen to set the measurement in place

Measures the diameter or radius of a circular object

Select diameter or radius

Click on the object to place 3 different points on the circle you're measuring

Click on the screen to set the measurement in place

Measures any angle on an object

Select angle

Place two points on the object to form the first line that the angle will measure from

Place another two points on the object to form the second line that intersects with the first where the angle will be measured

Move the cursor to the correct angle you want measured and click on the screen to place the measurement