Parts
No parts specified.
-
-
Check the Octoprint interface to see if the printhead and build plate has cooled down, proceed only when the build plate is at room temperature
-
Remove the flexplate by lifting at the two flanges
-
Rest your thumb on the edge of the build platform and twist upward using your index fingers as a lever
-
-
-
Flex the build plate and the prints should pop right off
-
If the print is not coming off, you can use the red spatula to release the edges of the part
-
-
-
Wipe towers, wipe walls or support material will need to be removed from the print
-
Wipe towers and walls can usually be pulled off by hand
-
Use pliers to pinch support material until it releases from the model
-
Use a pick for any leftover support material
-
Throw out any sacrificial material
-
-
-
Clean the build plate with IPA
-
Dry with a paper towel or cloth
-
Place the clean build plate back on the print platform
-
Be sure to align all sides of the plate to the build volume
-