Introduction
This guide has the basic information about the components of Nanoscribe print sets. The images are pulled from the NanoGuide Print Set Overview pages, which have more detailed descriptions of each print set. The Resin Overview pages contain general information and properties about common photoresists used with the Nanoscribe.
The NanoGuide support portal also has an interactive print set selector, which you can use to help guide your decision of what print sets you could use when you’re starting out.
If you are unsure how to go about using a non-standard print set or a resin that isn’t part of Nanoscribe’s IP series, please contact Terrapin Works (terrapinworks@umd.edu) or, for more complex cases, Nanoscribe support (support@nanoscribe.com).
-
-
Objective: 63x (DiLL mode)
-
Substrate: Fused silica slides
-
Photoresist: IP-Dip
-
-
-
Objective: 63x (Oil mode)
-
Substrate: Borosilicate glass coverslips
-
Photoresist: IP-L (+ Immersol oil)
-
Immersion oil- Immersol 518F
-
IP-G can be used in place of IP-L for prints that need a more viscous resin. To use IP-G, apply it to a clean slide and heated it at 100C for 1 hour before use.
-
Team
