05. Harvesting Build

Save the job report

Open the valves to let oxygen back in and regulate the environment

Raise the build plate up slowly

Carefully brush powder into the canisters on the right side

Repeat until the part is fully visible

DO NOT OVERFILL POWDER CANISTERS

Transfer full canisters to PX Box and replace with empty ones if necessary

Read powder handling dozuki

Pick up build plate and base and gently shake loose powder into canisters

Place build plate in open SAS door

You must be wearing:

Gloves

Jacket

Full PAPR

Move build plate to table

Use vacuum to remove any loose powder

Pound build plate on tabletop to loosen powder in through holes and support material

Hold up vacuum to capture any powder

Part should be fully cleaned of residual powder