-
-
Select "T,S,M" and select "Tools".
-
Tab down to the desired tool and press "In Manual."
-
Input the desired work offset in "T,S,M" then press Cycle Start.
-
-
-
Unlock the door in OP MODE 1 then switch to OP MODE 2.
-
Press the tool change button.
-
Holding onto the tool in the spindle(to either attach or detach), twist the clamp knob.
-
When attaching a tool, if it does not fully clamp, rotate the tool holder 180 degrees, as the dimple may have been facing the wrong direction.
-
-
-
In Manual Mode, select Tools. Select the tool you would like to unload and select Unload.
-
Open the carousel and remove the selected tool and replace with the desired tool.
-
Input the tool data in the controller.
-
Team
IFL: Senior Lab Managers and Lab Coordinators Member of IFL: Senior Lab Managers and Lab Coordinators
6 Members
48 Guides authored